The National Transportation Safety Board (NTSB) has closed its investigation into Southwest Airlines flight WN746. In May 2024, this Boeing 737 MAX 8 went into a Dutch roll between Phoenix and Oakland. The final report was published on November 5, 2026. According to the report, the rudder anomaly began nine days before the flight. The aircraft was parked in a thunderstorm, and the wind damaged it.
What happened on flight 746
Flight 746 left Phoenix for Oakland on the morning of May 25, 2024. There were 175 passengers and 6 crew on board the 737 MAX 8, N8825Q. Shortly after the aircraft reached cruise at 34,000 feet, it was in light turbulence. The captain felt what he called "a small amount of Dutch roll".
The first officer said that the tail was moving back and forth. Both pilots felt the rudder pedals move. The autopilot stayed engaged, and no warning lights came on. After a descent to 32,000 feet, the oscillations returned.
According to the report, the aircraft landed normally in Oakland, and nobody was hurt. Flight data showed rudder oscillations of about 0.75 degrees in each direction. They came in bursts of about 20 seconds.
Mechanics found the damage inside the tail. The vertical stabilizer's trailing edge ribs above and below the standby rudder power control unit (PCU) were damaged. The standby PCU is the backup hydraulic actuator that drives the rudder. Its forward support bracket was also damaged. One rib had fractured with signs of overload. The NTSB classed the damage as substantial.
A storm in New Orleans
On the night of May 16, 2024, the aircraft was parked at New Orleans International Airport. A squall line passed through. The airport's weather station recorded gusts of up to 73 knots, about 84 mph (135 km/h). Maintenance control was not told.
The NTSB notes that the 737's rudder has no gust lock. The main rudder PCU damps gusts so that they cannot slam the rudder into its stops. The standby PCU does not have this function. The investigators concluded that the wind probably moved the rudder hard enough to damage the ribs that hold the standby unit.
At that time, Boeing's 737 maintenance manual did not give a wind speed for a high wind inspection. Southwest also had no process to tell maintenance control about a parked aircraft in such a storm. So the check that could have found the damage was never done.
A check that missed the damage
After the storm, the aircraft made 38 flights. Nobody reported any rudder or yaw damper problems.
The second chance came on May 23 at Houston Hobby, during a scheduled "A Core Check". In the standby hydraulic test, a mechanic has to watch the rudder move to each stop. This would have shown that the rudder did not return to neutral.
Hangar security video showed the rudder moving right but not left. According to the report, nobody was at the tail to watch. Southwest maintenance still signed the test off as passed. The aircraft went back into service.
On May 24, on the fourth flight of the day, the crew disconnected the yaw damper. They said that it was overcorrecting. The yaw damper was deferred and then cleared after a functional test. The next day, flight 746 was the 44th flight since the storm.
The probable cause
According to the NTSB, the probable cause was damage to the connection between the standby rudder PCU and the vertical fin. An extreme high wind event caused this damage while the aircraft was parked. Nobody found the damage, and it led to abnormal operation of the standby rudder PCU.
Three factors helped the damage go unnoticed:
Southwest mechanics did not do the standby hydraulic test correctly;
Boeing's manual had no wind speed threshold;
Southwest did not have an adequate process to report parked aircraft hit by extreme wind.
The NTSB does not name a design defect in the rudder system as a cause.
Why the yaw damper made the problem visible
Dutch roll is a combined motion: the nose yaws and the wings rock in a repeating cycle. The 737 naturally tends toward Dutch roll. Its yaw damper works against it with small automatic rudder inputs. These inputs are limited to 3 degrees of rudder travel.
Flight data showed that every oscillation happened with the yaw damper engaged. There were none when it was switched off or deferred. After the Houston check, yaw damper commands also matched rudder pedal movement. This had not happened before. Normal yaw damper inputs do not move the pedals.
That is why the crew on May 24 blamed the yaw damper. The real fault, however, was the damaged mounting of the standby rudder PCU.
What has changed since
According to the report, Southwest inspected the rudder PCU mountings on all its 737 MAX aircraft. It found nothing abnormal. The one-line instruction for the standby hydraulic test was replaced with a step-by-step work card. Each assigned mechanic now signs it.
The airline now tells maintenance control when parked aircraft go through an extreme wind event. Boeing changed the 737 manual. The high wind inspection now starts at 75 mph, or 65 knots (121 km/h). The gusts at New Orleans, 73 knots, were above this threshold.
